A set of seven dice including an extra decader d10 for generating percentile results.

1/144 Fokker D.VII German WWI fighter.

Perfect for the wargamers and collectors.

Please, see instruction before build model.

Weighted Companion Dice.  Features 6 sides with a heart for the number 1. Sized the same as a standard dice.  Picture shows White Detail (Left) and White Strong and Flexible (Right) materials.  Order includes only one in your choice of material.  

Spaaaaaaaaaaace!

Version 1.5

A 5-pack of the hungriest pestilence found in the universe! Each scrapacius has a hinged jaw and ball-jointed neck joint. The legs are designed to grab onto 3mm diameter rods. Enjoys cuddling.
Each Scrapacius stands about 2cm tall.

This design is successfully tested in FUD and WSF. FUD is recommended to capture all the fine detail.

TFW2005 Radicon thread here.

1/144 Airco DH.2 British WWI fighter.

The D.H.2 biplane was Geoffrey de Havilland's second design for the Aircraft Manufacturing Company. This highly successful pusher had good maneuverability with an excellent rate of climb. Mounting the engine to the rear of the fuselage permitted the use of a fixed, forward-firing machine gun before the advent of the synchronous machine gun. Superior to the Fokker E.III, the D.H.2 helped end the "Fokker Scourge." Well past its prime and almost two years after its introduction, some squadrons of the Royal Flying Corps were still equipped with D.H.2s.

Perfect for the wargamers and collectors.

In response to requests from friends and supporters, I did a revised version of my posable hands for the DOTM leader Sentinel Prime figure, this time to be much more movie accurate and with even more detail!

Each hand is articulated at the wrist with a ball joint. The fingers each are double jointed, and even the thumbs are on ball joints. The leader's hands are big enough for me to design it such that it can hold weapons without relying on the tension of the finger joints, so you can pose them in many different ways, with many different weapons. Transformation is very much possible, I made sure of that (yay!). Just make sure the fingers are arranged properly, kinda similar to how the original fingers were. IssuesThe test sample has a loose wrist ball-joint. This issue is not fixed as I used the same measurements as my other hands. Those hands came out with tight joints so it beats me why this sample was loose. Use super glue to tighten if necessary. As the joints are all designed to be sturdy and the pieces are kinda chunky, I will not recommend ordering them in Detail material or Frosted Ultra Detail material as they will most likely break under that pressure. However, I still will make these materials available for those who are picky about their surface detail. Buyer beware!

TFW2005 thread here. (Includes assembly instructions)
Flickr gallery here.

1/144 Albatros D.II German WWI fighter.

The Albatros D.II was a modified version of the Albatros D.I. Pilots complained that the D.I offered poor visibility from the cockpit. To solve this problem, the D.IIs upper wing was brought closer to the fuselage. Mounted to the fuselage in front of the pilot, the D.IIs twin, synchronous machine guns set the standard for other German and Allied fighters. By the end of 1916, increased production of the Albatros gave Germany numerical superiority in the air war.

Perfect for the wargamers and collectors.

This chess set re-imagines the bodies of the traditional chess pieces to incorporate each piece's name as the focal point of their design. It should be noted that each color/material must be ordered separately. This does, however allow for mixing and matching.