Customise your iPhone cases surface pattern online - copy and paste the link below into your browser: http://thingsmaker.com/create/wizard?start_p...

This is a fun 1/16 music note that can be used to decorate in a music room or anything musical. It has been tested for sturdiness and is quite robu...

iPhone 5

For use in either handheld shooting scenarios where a tripod mount point is not needed or to attach to rail systems or camera rig, in which case yo...

Adapter ring for helix lamp and E27 bulb socket. This part can be downloaded and modified if necessary.

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

Can be used as business card

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Landing gear for light Quadrocopters. For standard 10x10mm beams

Guitar Pick with the Zelda Triforce Symbol. 1 mm thick

for servo "Modelcraft ES-05"

Display Case part DIY 87mm diameter x 90mm height display volume Waste as a resource

'Pentagon' Iphone 4-4s case

Table top Roller Coaster, there is 2 ways to print this model. 1. print entire assembly with body and wheels. 2. print body and wheels separately...

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...

A stand that goes along with the pentagon case

Lenscap to integrate lens with eyepiece.

If you own a Sony wireless bluetooth lapel microphone (models ECM-AW3 or ECMHW2) you can place the microphone unit into the top and cover it with ...

This pulley is for project 10-3 in my book - for more information visit www.makingthingsmove.com.  It's way bigger than it needs to be (so it'...

Lock for running shoes speed laces. Laces through the round piece, wedge in, squeeze wedge to lock it in it's place. Remember to print a pair, one ...

3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

Clothing or shirt clip for my Apple EarPods.

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.