by
3DBK
A case that will safely hold 7 cigarettes and stay closed with your lighter so you always have both on you. Lighter snaps in and slides out.
NOTE: Has only been tested on my Cube printer using ABS, I have not tried any other materials.
by
dhdecandia
1 required for whole assembly
This is the half of the palm that supports the pinky and the 3rd finger of the bob
by
bfinio
Mold for soft robot from this project on Instructables: http://www.instructables.com/id/Air-Powered-Soft-Robotic-Gripper/. Be sure to order material with a smooth surface finish - silicone rubber will adhere to rough surfaces, and be difficult to de-mold without tearing.
by
dhdecandia
1 required for whole assembly
This is the 'saddle joint' of the thumb that gets installed into the palm
by
dhdecandia
1 required for whole assembly
This is the first bone of the pinky, just off the pinky knuckle
by
griffey
Plain blade plug, sized for 1" saber. The top of the plug has a recessed area that fits a US Penny (for reference) that could be fitted with a washer, colored epoxy, or lots of other decorations. Or, left plain, the White Strong and Flexible material gives a nice soft glow even without.
by
dhdecandia
1 required for whole assembly
This is the bottom, thumb, long-bone just attached to the saddle joint
