Landing gear for light Quadrocopters. For standard 10x10mm beams

Guitar Pick with the Zelda Triforce Symbol. 1 mm thick

for servo "Modelcraft ES-05"

Display Case part DIY 87mm diameter x 90mm height display volume Waste as a resource

'Pentagon' Iphone 4-4s case

Table top Roller Coaster, there is 2 ways to print this model. 1. print entire assembly with body and wheels. 2. print body and wheels separately...

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...

A stand that goes along with the pentagon case

Lenscap to integrate lens with eyepiece.

If you own a Sony wireless bluetooth lapel microphone (models ECM-AW3 or ECMHW2) you can place the microphone unit into the top and cover it with ...

This pulley is for project 10-3 in my book - for more information visit www.makingthingsmove.com.  It's way bigger than it needs to be (so it'...

Lock for running shoes speed laces. Laces through the round piece, wedge in, squeeze wedge to lock it in it's place. Remember to print a pair, one ...

3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

Clothing or shirt clip for my Apple EarPods.

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

Custom made adapter for all 3M sanders with self generated vacuum, so a tool balancer can be connected in a better and more secure location, great ...

Earbuds designed by C. Stovall

This is interchangeable backplate is designed to be used in conjunction with the Graft Concepts Leverage i5 case for the iPhone 5, which is sold ...

Couch for iphone or ipod touch.

2 required for whole assembly This is the knuckle-joint for the middle, two fingers of the bob

A knob for my air conditiner, based on this model from Thingiverse.