These are the herringbone pattern gears used in the Printrbot's extruder, designed by Brook Drumm (gears from Wade's Most Excellent Extruder). The...

This is the second hardness sensor i made. The two reasons that pushed me to do an HS2 is that the first one was too expensive, even if better, and...

A pneumatic gripping device I designed for use in an assembly line. It uses a central "piston" to move the hinged jaws open or closed.This model is...

SHAPED TRANSMITTER CONE FOR PING TYPE ULTRASONIC SENSOR   A low cost way to wring the maximum DIRECTIONAL performance from ...

This is a stock Losi Micro servo mount for custom chassis'. This will secure your servo to the chassis without the use of thick two-sided tape. Thi...

Mechanical eyelid assembly for a 20mm eyeball.

He''s here, and he''s still upset about Global Warming! We all know that neither bears, nor robots, do well in water...

Fully functioning gear box.When turning any gear will drive all other 5 gears. Transmission ratio is 1:1.

A smaller version of RealBot.