Finally the official release of the SkyLight SBG Digital Brushless Gimbal for GoPro Hero 2 HD Cameras!! Designed for the AlexMos SImple Brushless ...

This mounting bracket can be used to assembly and align the EMG 30 DC gearmotor. (also motors in diameter range from 25 – 33 mm) The M4 th...

This Keepon® VRML model by BeatBots is provided for the Shapeways "My Keepon" Challenge. It is licensed under a Creative Commons Attribution-NonCo...

Allows mounting your flight controller board at a different angle than your power board or frame mounting holes. 3mm Holes at 45mm and 35mm to f...

92mm PC Fan Grill with custom text on it.

Robots need caffeine too! This little surprise is hiding from the chaos of your desktop, simmering in his little world of mocha glee!

Recessed 1" (25mm) Miniature Hex Base - Indented with the Mochi Boy logo!

120mm PC Fan Grill.Personalized version available at http://www.shapeways.com/model/170984/personalized_fan_grill_120mm.html

The feet part of the landing gear of the quadcopter frame (under development).

80mm PC Fan Grill.Personalized version available at http://www.shapeways.com/model/170981/personalized_fan_grill_80mm.html

These are the herringbone pattern gears used in the Printrbot's extruder, designed by Brook Drumm (gears from Wade's Most Excellent Extruder). The...

This is the second hardness sensor i made. The two reasons that pushed me to do an HS2 is that the first one was too expensive, even if better, and...

A pneumatic gripping device I designed for use in an assembly line. It uses a central "piston" to move the hinged jaws open or closed.This model is...

Rover ver 6.0, holder for bearing (inside each tube), Team Plan B, Googe Lunar XPRIZE. For rover (model) require -8 For ground station - 8 http://w...

SHAPED TRANSMITTER CONE FOR PING TYPE ULTRASONIC SENSOR   A low cost way to wring the maximum DIRECTIONAL performance from ...

This is a stock Losi Micro servo mount for custom chassis'. This will secure your servo to the chassis without the use of thick two-sided tape. Thi...

Mechanical eyelid assembly for a 20mm eyeball.

He''s here, and he''s still upset about Global Warming! We all know that neither bears, nor robots, do well in water...

Desktop stand for your Arduino Uno and Leonardo. High model. You can click on the board easy. The space underneath can be used to store a PC speake...

Fully functioning gear box.When turning any gear will drive all other 5 gears. Transmission ratio is 1:1.

A smaller version of RealBot.

updated version in 0.7mm it should fit for the 1mm version also.

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

Lid is used two times for Body

This suits the shaft of the Low Cost Motors from MUTR.Co.UK

Allows mounting your flight controller board at a different angle than your power board or frame mounting holes. 3mm Holes at 45mm and 30.5mm to...

For 8.5mm Motors,v202/H36/V939 and also v929/959 boards and 300mah up to 600mah Batteries are possible

A robot that comes with a stand.

Micro Quadrocopter Frame with mounting holes for 45mm flight controller. See it flying here: http://vimeo.com/moogaloop.swf?clip_id=63350985&full...

Chassis for my 150g fighting robot Keres.