A Pair of Mark 2 Anthromod hands. Left and Right. A robotic hand that is fully printable. Development blog

This is part 2 of the GoPro gimbal. This part ties parts 1 and 3 together. The pitch and roll servo arms will bolt to this part.

3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

Gripper's Claw

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

Die Manipulatorzange für das Modell DeepRover DR1002 (http://modelluboot.de/KITS/DeepRover/DeepRover1002.html). Nicht beweglich. In Strong and Fle...

The Anthromod Mark 2 left hand. A robotic hand that is fully printable. Development blog

Module 0.5 Pressure angle: 25° Teeth: 10 Primitive diameter: 5mm Overall diameter: 6mm Bore diameter: 2mm Teeth height: 4mm Hub height: 5mm Overal...

this is a wheel for a robot or rc car or whatever it has a 3mm hole in the middle that can be drilled out for larger gear motors. it has a standard...

A ratchet wheel that is 12mm in diameter, 14mm tall.

Rover ver 6.0 / Ground station v 1.0, 2.4 Ghz helical antenna, Team Plan B, Googe Lunar XPRIZE. For rover (model) require -1 For ground station - 1...

PLAIN CONE FOR PING TYPE ULTRASONIC SENSOR   A low cost way to wring the maximum DIRECTIONAL performance from your ultrason...

MookaFrame3D: arm. This is the arm of the MookaFrame, to be attached to the main body.

part of a robot (eurobot2011)

This is the mounting base to the GoPro gimbal, and it is intended to be bolted to your vehicle. The part is designed to fit a Hitec HS-125 or HS-51...

part of a robot (eurobot2011)

Not Tested yet, but this is basically just a mecano set, (or whatever they are called), you can use the small cylinder and cube to connect togeathe...

2 required for whole assembly This is the knuckle-joint for the middle, two fingers of the bob

motor mount for gimble.

Module 0.5 Pressure angle: 25° Teeth: 10 Primitive diameter: 5mm Overall diameter: 6mm Teeth height: 4mm Axe diameter: 2mm Axe overall length: 7.4mm

Maxbotix sonar mount for RC helicopter with 19mm diameter tail boom Not yet tested (but it's probably fine)

Conversion kit for Animated Blur to convert to Arcee. Includes Head and transformable pods.

Open Source 2 Axis Brushless Gimbal for the AlexMos Brushless Gimbal Controller. BETA v1.09

this is the smallest i can make a wheel diameter wise that will fit the micro gear motors http://www.pololu.com/catalog/product/998 and it has the ...

Tube bracket to hold a 20mm (OD) tube in the Flexacopter. Holes are for m3 bolts. Plate distance is about 22mm after clamping the tube.

Module 0.5 Pressure angle: 25° Teeth: 10 Primitive diameter: 5mm Overall diameter: 6mm Teeth height: 4mm Bore diameter: 2mm

Want a gear on the top of a micro-servo? Here is what you want ! (Suggest to use Frosted Detail or Frosted Ultra Detail)

"Decepticon Logo" Software: 3Ds Max 2013, KeyShot 4 Pro. Hardware: Intel DX79SI, i7-3960X, 64GB RAM, GeForce GTX 690. See full work at: http://bit....