Right from the laboratory.

Part to be used as support for the light foam wheel. - part of the quadcopter frame (under development)

Finally the official release of the SkyLight SBG Digital Brushless Gimbal for GoPro Hero 2 HD Cameras!! Designed for the AlexMos SImple Brushless ...

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Landing gear for light Quadrocopters. For standard 10x10mm beams

for servo "Modelcraft ES-05"

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...