Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the end of the wire leg or the wide end of the cross arm.

Lid is used two times for Body

This suits the shaft of the Low Cost Motors from MUTR.Co.UK

Allows mounting your flight controller board at a different angle than your power board or frame mounting holes.
3mm Holes at 45mm and 30.5mm to fit KK Multirotor, Multiwii (most) and Openpilot CC boards. Should fit any board with 45mm or 30.5mm hole to hole mounting size.
Note: Will not fit Multiwii NANO board (35mm mounting hole to hole)

For 8.5mm Motors,v202/H36/V939 and also v929/959 boards and 300mah up to 600mah Batteries are possible

A robot that comes with a stand.

Micro Quadrocopter Frame with mounting holes for 45mm flight controller. See it flying here: http://vimeo.com/moogaloop.swf?clip_id=63350985&fullscreen=1&autoplay=1

92mm PC Fan Grill.
Personalized version available at http://www.shapeways.com/model/170983/personalized_fan_grill_92mm.html

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

Desktop stand for Arduino Uno / Leonardo to protect your desktop for scratches and protect for short circuit. You can easy click the board on te stand. Removing the board from the stand is very easy to do. It also can use this stand to mount the Arduino Uno / Leonardo to a board or wall.

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Rebel look for My Keepon. Additional photos show digital sketch and DIY kit.

not tested jet but very light ... about 7g only!

This is the GoPro gimbal part 1. It holds the GoPro and also fits a Hitec HS-65 or HS-5065 servo for pitch stabilization. The servo's output shaft is aligned with the pin on the opposite side. The pin fits into part 2 which acts as a bearing.

Clip that snaps on Fanuc teach pendant with rigid top handle. Leave it snapped onto teach pendant to hang on fence, or on controller. Back hooks engage into 1 x 1” fence. Overall size small enough to not interfere with controller teach pendant hangar wire. Available in various colors.

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d printer. This model prints 10-up to help keep the cost around $5/each.

Rover ver 6.0, holder cover, Team Plan B, Googe Lunar XPRIZE. For rover (model) require -4 For ground station - 4 http://www.adobri.com/ProjectVe.aspx

MookaFrame3D: internal upper plate

Consists of 6 gears.

In nature state, the gears are locked each other.

When push a pair of buttons (in opposite pair), then two gears get detached and the other 4 gears are able to spin.

this is a small wheel for the micro gear motors. it has a standard hub that can be used with most hubs with the 6.35mm spacing