3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

2 required for whole assembly This is the knuckle-joint for the middle, two fingers of the bob

motor mount for gimble.

Maxbotix sonar mount for RC helicopter with 19mm diameter tail boom Not yet tested (but it's probably fine)

Mold for soft robot from this project on Instructables: http://www.instructables.com/id/Air-Powered-Soft-Robotic-Gripper/. Be sure to order materia...

Compass mount for tail of Trex450 This has not been tested yet. I might eventually combine the compass mount with the sonar mount.

Motor mount for an automated Etch-a-Sketch

1 required for whole assembly This is the index finger, or pointer finger, or 1st finger, knuckle-joint of the bob

1 required for whole assembly This is the 'wrist' of the bob