http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=38208&th=7016#msg_38208 volundr 2011-11-09T01:20:08-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=38222&th=7016#msg_38222
Bart]]> bartv 2011-11-09T08:01:09-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=38628&th=7016#msg_38628 volundr 2011-11-15T18:32:06-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=38728&th=7016#msg_38728
Thanks!

Bart]]> bartv 2011-11-17T08:25:44-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=38737&th=7016#msg_38737 Youknowwho4eva 2011-11-17T13:47:54-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=38979&th=7016#msg_38979 volundr 2011-11-21T18:14:55-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=39119&th=7016#msg_39119
More then 2.8k errors... no good... ]]> pfeiffer stylez 2011-11-23T13:47:17-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=39149&th=7016#msg_39149
I had a look at the Sketchup file and found quite a few issues, mainly where individual componets were just sitting next to each other, un-attached. I have fixed the issues that I could see, so hopefully it will have helped bring the cost down a bit. Please give the model a check to make sure that I havent changed anything that was essential to the design of the part while I was fixing bits.]]> Kasss_Gnarl 2011-11-23T18:59:07-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=39157&th=7016#msg_39157 volundr 2011-11-23T20:45:34-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=39162&th=7016#msg_39162 ]]> Kasss_Gnarl 2011-11-23T21:23:21-00:00