http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=35924&th=6611#msg_35924
well i'm about 2/3weeks thinking of how it works..
and i don't have any clue..

you can make a neck but it will go down to eath because of the gravity force..

and on the photo it will be set on the position you want..


any idea's how this Technic works and the name for it?


gr.]]> janis 2011-10-05T12:57:00-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35926&th=6611#msg_35926
]]> pfeiffer stylez 2011-10-05T13:19:13-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35973&th=6611#msg_35973

danke da fur.

well now i need to know how it works hahah...


gr.]]> janis 2011-10-05T19:21:20-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35974&th=6611#msg_35974 stannum 2011-10-05T19:28:54-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35975&th=6611#msg_35975
is it possible that can draw it, because i'm not totally following..

gr.]]> janis 2011-10-05T19:33:01-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35976&th=6611#msg_35976 Youknowwho4eva 2011-10-05T19:43:23-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=35980&th=6611#msg_35980
In principle it is not a lot different to this, but it would take a fair bit of tinkering to make it work as a one piece print... it could probably be done quite easily with snap fit ball joint type parts as a multi-piece print though.

Paul

]]> stop4stuff 2011-10-05T19:58:11-00:00