http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=8226&th=1714#msg_8226 I use Solid Edge CAD for my design work.
The object I have attached is giving me non-manifold grief.
SE doesn't tell me of any problems, and from fumbling with Rhino4 all I know is:
Mesh has 10 degenerate faces.
Mesh has 6 non manifold edges.
but I don't know where the problem areas are on the model.
If someone could please tell me where the problems are, or even fix if its not too much trouble, I would be most appreciative.
Thanks,
Mark]]> Mark_Kendrick 2009-12-11T01:12:30-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=8227&th=1714#msg_8227 Netfabb. It's free, and it works really well for identifying problem areas. Endorsed by SW, too.

http://www.netfabb.com/

]]> dadrummond 2009-12-11T02:05:31-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=8229&th=1714#msg_8229
I did a test upload and it uploaded successfully too ]]> Inlite 2009-12-11T03:32:41-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=8230&th=1714#msg_8230 Not being a practising surface modeller, netfabb didn't make a lot of sense to me, but i think I worked out the problem through trial and error.
Got there in the end,
Thanks
Mark]]> Mark_Kendrick 2009-12-11T04:06:20-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=8231&th=1714#msg_8231 I will have a look at yours and see what went wrong, much appreciated!
-Mark]]> Mark_Kendrick 2009-12-11T04:07:24-00:00