http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=60844&th=12567#msg_60844
What do you think?

(Note - the design will be symmetrical. I'm right-handed, so the right side of the drawing always looks better than the left. That's why I often don't bother to draw both sides when it is symmetrical)

]]> TurtlesAreCool 2013-01-26T15:54:32-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=60868&th=12567#msg_60868
Thoughts on other ways I could use this?

http://www.shapeways.com/model/891968/]]> TurtlesAreCool 2013-01-26T23:48:12-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=61756&th=12567#msg_61756
I think I'll try out the FCS material with it. Any thoughts? Should I make it a flat object with thickness (i.e. something that you might hang as a decoration) or something else?

]]> TurtlesAreCool 2013-02-10T21:58:38-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=61826&th=12567#msg_61826
Ray]]> Ray716 2013-02-11T21:33:08-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=61849&th=12567#msg_61849 UniverseBecoming 2013-02-12T08:26:02-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=62113&th=12567#msg_62113 ]]> natalia 2013-02-15T14:56:05-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=62117&th=12567#msg_62117
I haven't tried the FCS print yet, but here's my quickie paint job on the test print I got the other day. I think it looks pretty good, although it lost some detail because I had to make the engraving shallower due to wall thickness issues. Personally, this is small enough that I think it would have been fine and was willing to accept the risk of a poor print, but w/e. I was breaking the rules pretty badly in this case.
]]> TurtlesAreCool 2013-02-15T15:13:05-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=62119&th=12567#msg_62119 ]]> UniverseBecoming 2013-02-15T15:24:51-00:00