http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=60245&th=12419#msg_60245
IMO it came out great, though I admit I have pretty low standards for this sort of thing, as I'm more of a geek than an artist

Alas, there's a small gap at the left edge of the light switch plate where it doesn't quite cover the hole for the switches... not sure what I'll do about that, if anything. It's my own fault for not measuring the hole behind the original switch plate more closely.

The unpainted light switch plate (2 parts):


Drying:


Finally installed:
]]> RogerN 2013-01-15T05:34:30-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=60267&th=12419#msg_60267 FabMeJewelry 2013-01-15T19:46:23-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=60331&th=12419#msg_60331 Ray716 2013-01-17T01:58:24-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=60457&th=12419#msg_60457 Mhagan 2013-01-20T22:59:34-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=60460&th=12419#msg_60460
]]> LincolnK 2013-01-21T05:40:40-00:00