http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=57662&th=11769#msg_57662
]]> jeremyzschau 2012-11-29T12:30:25-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=57669&th=11769#msg_57669 Youknowwho4eva 2012-11-29T14:39:12-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=57684&th=11769#msg_57684
Ignore the comments about the normals. I had a confusion attack. You have two holes, the inner hemispheres upper edge and the outer surfaces upper edge. Netfab will just close the outer cups edge when you try to repair it,leaving 2 shells. I bet you will wind up having to perform a boolean operartion, or manually connect verts, and fill holes

]]> Fredd 2012-11-29T17:18:07-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=57735&th=11769#msg_57735 ]]> jeremyzschau 2012-11-30T09:36:38-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=57806&th=11769#msg_57806 Click on repair, Red Cross
Hover over the icons at the top till you find 'Add Triangles' Click this
Pick one of the edges. It will turn blue. Pick another face over the red internal part.
A new face will be created.
Right click on the edge of the new face and pick 'Close Hole'.
The internal red is covered by a new face.
Flip model over and do the same on the other side.
Once done. Click on Apply Repair.
Go to Part - Export part.
Export as STL.]]> JACANT 2012-12-01T02:10:11-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=57850&th=11769#msg_57850 Fredd 2012-12-02T02:49:46-00:00