http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=56084&th=11370#msg_56084
I've uploaded it to this post, but will be taking it down as soon as my problem is resolved.
EDIT: Removed, problem identified.

EDIT: I also wasn't sure which forum to post this in, so took my best guess.]]> PeregrineStudios 2012-10-28T02:29:35-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=56085&th=11370#msg_56085

See the triangles in green? They don't stop at the edge of the raised detail, but rather they run THRU it.. all the way across the face.

You need to either re-apply the boolean join that you attempted, or you need to try running it thru http://cloud.netfabb.com to see if that software can repair it.]]> stonysmith 2012-10-28T03:26:27-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=56086&th=11370#msg_56086
Can you tell me what program you used to inspect the model and find the error? Was there an automatic check or did you have to look manually? I'd like to be able ti figure out for myself rather than running to the forums for help every time.

Thanks again!]]> PeregrineStudios 2012-10-28T03:32:04-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=56088&th=11370#msg_56088 1. Ring for the chain
2. extruded circle, with indentation at it bottom
3. Embossed dragon design
Part 1 was boolean joined to part 2. Section 3 was not boolean joined to section 2. So the results were not 1 unified surface. Try just selecting parts 1,2,3 export as a stl, do not join meshes, upload to SW.
I worry that the indentation at the bottom, if the mesh is unified, might cause problems.
By the way, netfabb basic is a great help. but when you import a model there joined meshes causes problems.
Its just the logo area was joined with part 2, making both 1 mesh, along with part 1 being part of part 2.

That is what you call a oopsy. A simple mistake causing massive headaches]]> Fredd 2012-10-28T04:26:50-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=56089&th=11370#msg_56089 PeregrineStudios 2012-10-28T04:30:50-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=56090&th=11370#msg_56090 Fredd 2012-10-28T05:18:47-00:00