http://www.shapeways.com/forum/index.php Shapeways: Bring your creativity to life in 3D http://www.shapeways.com/forum/index.php?t=rview&goto=55078&th=11116#msg_55078






It turned out that this did not generate any sort of interest what so ever... it might be because it required a fair amount of assembly.

I have now just combined the cubes so there is no assembly required




This method is quite a bit cheaper as I can scale things down, but now I am a little worried that I might be breaching some copyright laws. :/
]]> BITGEM 2012-10-09T09:47:03-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=55090&th=11116#msg_55090 (And stating here "in public" that you already suspect you might get in trouble over this
is probably not the brightest move either, if you hope to rely on the "fair use" clause)]]> mkroeker 2012-10-09T14:32:32-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=55098&th=11116#msg_55098 BITGEM 2012-10-09T16:48:55-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=55111&th=11116#msg_55111
About the technical details, are the cubes 6mm? Did you get any complain from service about too many and too small parts, or was it printed without questions?]]> stannum 2012-10-09T22:22:49-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=55175&th=11116#msg_55175
About the technical limitations... I received no complaints. I suppose it was still within the limits plus the parts are simple cubes and are probably easy enough to handle. I have tried to upload a street fighter sprite in single cubes before... that blew up the system .]]> BITGEM 2012-10-11T06:53:57-00:00 http://www.shapeways.com/forum/index.php?t=rview&goto=55422&th=11116#msg_55422 BITGEM 2012-10-16T07:03:12-00:00