Home » Community » It arrived! » My first ring
Search Search  
My first ring [message #50352] Mon, 25 June 2012 19:10 UTC Go to previous message
avatar Sapro  is currently offline Sapro
Messages: 11
Registered: March 2012
Go to all my models
Junior Member
Hi everyone,
I just wanted to share a couple of pictures of my first creation with shapeways!
The final version is printed in silver glossy and polished.
index.php?t=getfile&id=17916&private=0
As it was expected it wasn't possible to polish inside the small groove but I think it gives a nice texture contrast.
index.php?t=getfile&id=17917&private=0
I have put some shot of the WSF prototype (with the gem intended for the silver ring) so you can see how good the details are in silver.
index.php?t=getfile&id=17918&private=0
The only issue is that shapeways left some of the building support in silver. So I will have to deal with these myself Crying or Very Sad
index.php?t=getfile&id=17919&private=0
What do you think? Any ideas how to improve even more the surface finish of small silver features?
I noticed a couple of "dirt' mark on the silver ring which were easily removed by hand.
index.php?t=getfile&id=17920&private=0

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Horseshoe crab
Next Topic:I'm really disappointed :(
Goto Forum:
   Go