Home » Community » It arrived! » Origami Crane in FD, robotic finger in WSF
Search Search  
Origami Crane in FD, robotic finger in WSF [message #50170] Fri, 22 June 2012 00:05 UTC Go to previous message
avatar arklan  is currently offline arklan
Messages: 76
Registered: December 2011
Go to my shop
Member
so happy with how these turned out.

the Origami crane, wingspan 7 cm or 2.75 inches.
index.php?t=getfile&id=17790&private=0

a comparison of the printed crane to it's larger folded brother.
]index.php?t=getfile&id=17793&private=0

and a printed finger with working joints (too loose currently - will fix that later.) that's part of my attempt at a victorian prosthetic hand i found a picture of.
index.php?t=getfile&id=17792&private=0

Read Message
Read Message
Read Message
Previous Topic:Stampmaker
Next Topic:HandiCube by OSKAR
Goto Forum:
   Go