Bushings from 1/2" to M12 (12mm) - 3D modeler needed on Shapeways Discussions about 3D Printing

Home » Community » 3D modeler needed » Bushings from 1/2" to M12 (12mm)

Bushings from 1/2" to M12 (12mm) [message #50130] Wed, 20 June 2012 21:16 UTC

olavxxx
Messages: 5
Registered: March 2012
Go to all my models

Junior Member

Hi,
LOOK BELOW

[Updated on: Thu, 21 June 2012 18:02 UTC]

	Bushings from 1/2" to M12 (12mm) By: olavxxx on Wed, 20 June 2012 21:16 UTC
	Re: Bushings from 1/2" to M12 (12mm) By: olavxxx on Thu, 21 June 2012 17:15 UTC
	Re: Bushings from 1/2" to M12 (12mm) By: CADNinja on Thu, 21 June 2012 23:18 UTC
	Re: Bushings from 1/2" to M12 (12mm) By: pfeiffer stylez on Fri, 22 June 2012 00:23 UTC
	Re: Bushings from 1/2" to M12 (12mm) By: olavxxx on Fri, 22 June 2012 21:15 UTC

Previous Topic:	Scaling Up Models
Next Topic:	Need 3D model for pizza oven

Goto Forum:

Current Time: Sat May 25 00:07:56 UTC 2013

Don't miss Shapeways Live