Home » Support » 3D Printing »

model rejected due to ratio thickness/length

Search Search  
model rejected due to ratio thickness/length [message #25159] Wed, 23 March 2011 12:05 UTC Go to previous message
avatar tebee  is currently offline tebee
Messages: 477
Registered: December 2010
Go to my shop
Senior Member
I've had a model rejected with "ratio thickness/length" - see the attached pic.
it's this model http://www.shapeways.com/model/220271/oo9_bogie_flat_with_st akes_and_ends___long_.html?gid=ug61704

OK I can see it's long and narrow but I've has similar things print before and I can't seem to find any guidelines as to what will or will not work.

Anybody point me to these?

One other minor point the rejection letter does not tell me in what material the model was ordered


  • Attachment: 109822-1.JPG
    (Size: 36.25KB, Downloaded 292 time(s))

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Best Keychain material
Next Topic:Print errors on bottom of WSF objects
Goto Forum:



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.