Home » Support » 3D Design » How do I make it hollow?
Search Search  
How do I make it hollow? [message #19850] Fri, 29 October 2010 14:44 UTC Go to previous message
avatar jglantz  is currently offline jglantz
Messages: 1
Registered: September 2010
Go to all my models
Junior Member
I am a total noob to Shapeways and 3d modeling in general.
I want to make my model hollow, otherwise its insanely expensive to order it.

Does anyone have any ideas or advice on how can I do that? I used CB Model Pro to create it, because I can't figure out any other 3D program.

if anyone can point me in the right direction I'd really appreciate it. Also, if I want it to be rescaled...do I have to do that or is there some way to specify that when ordering?

Thanks

its a model of my hedgehog...

http://www.shapeways.com/model/170617/hedgehog.html?gid=ug52 593

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Design, structurally sound
Next Topic:The best Ball Joint ratio?
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.