Home » Community » It arrived! » My recumbent bike arrived
Search Search  
My recumbent bike arrived [message #7943] Sat, 28 November 2009 15:55 UTC Go to previous message
avatar BAROBA  is currently offline BAROBA
Messages: 124
Registered: August 2008
Go to my shop
Senior Member
Hi all,

Shapeways did a good job on printing this one out Smile
There are really thin parts on this bike, they look fragile but they they are quite strong. I designed some parts to be rotatable, but unfortunately they fused together. The tolerances need to be bigger then 0.2mm. Something new I learned Smile

Here are the pictures, the small spikes sticking out are part of the print. They form a connection between the stand and the bike. It can easily be cut and removed.




[Updated on: Sat, 28 November 2009 15:56 UTC]

Read Message
Read Message
Read Message
Read Message
Previous Topic:Floppy 2x3x3 by OSKAR
Next Topic:Shapeways' 3D prints, part of an exhibition in Athens
Goto Forum: