Home » Support » 3D Design » Non-manifold in Rhinoceros
Search Search  
Non-manifold in Rhinoceros [message #7663] Sun, 08 November 2009 14:01 UTC Go to previous message
avatar rxpincho is currently offline rxpincho
Messages: 3
Registered: July 2009
Go to all my models
Junior Member
Hi everybody,

I am making a package for a jewel i am making, already 4 pieces of it i've uploaded succesfully. These are far more complicated than this last part. I've checked the part with MiniMagics. It seems to be that there are no problems with bad edges or something.
If I upload only the half balloon shape it's oke, only with the clips on it it failes over and over again.

It would be awesome if someone could help me out with this problem!

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:manifold error
Next Topic:HELP Why does model look like this?
Goto Forum:
   Go
Generate printable PDF   


Current Time: Mon May 20 17:29:32 UTC 2013