Home » Support » Buying » Question about uploading
Search Search  
Question about uploading [message #69824] Fri, 14 June 2013 12:38 UTC Go to previous message
avatar AMPUSA  is currently offline AMPUSA
Messages: 1
Registered: June 2013
Go to all my models
Junior Member
Im a bit new to this whole 3d printing. I had someone create 4 stl files to create a 30 round magazines for an AR-15. Im not sure If I should be uploading in millimeters or inches? I tried in milimeters and it says 2 of my files are to small to create. The inches were ok. Any help?

Read Message
Read Message
Previous Topic:Any update on non-UPS shipping options?
Next Topic:Bug in Sandstone pricing?
Goto Forum:
   Go