Home »  » 3D modeler needed » Need Simple Logo Made 3D To Slap on Draft Beer Machine ;)
Search Search  
Need Simple Logo Made 3D To Slap on Draft Beer Machine ;) [message #66308] Thu, 18 April 2013 00:29 UTC Go to previous message
avatar faceyspacey  is currently offline faceyspacey
Messages: 1
Registered: April 2013
Go to all my models
Junior Member
Hey guys, I need to make the logo in the top left of the following site I'm developing made into a 3D version:

http://kombucha.meteor.com


If you scan down the page, you'll see the logo on the front of a draft beer machine. We're using the machine to sell Kombucha in bars in restaurants.


We also need a plan to stick it to the front of the machine. Probably super glue can just handle it.


Contact me, and let me know if you're capable of it, and how you'd go about it, how much you'd charge, etc, and any questions you might have. We just need the logo to be about 3 inches wide, 1 inch tall, and about half an inch deep. Something like that.



ps. the photoshop .psd of the logo are attached.

  • Attachment: cklogo.psd
    (Size: 96.12KB, Downloaded 40 time(s))

Read Message
Read Message
Read Message
Previous Topic:3D MODELLER NEEDED FOR FAST MODELING
Next Topic:Small Moose
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.