Home » Community » Work in progress » Material Question
Search Search  
icon5.gif  Material Question [message #65516] Fri, 05 April 2013 03:16 UTC Go to previous message
avatar pintamicerca  is currently offline pintamicerca
Messages: 1
Registered: May 2012
Go to all my models
Junior Member
Good evening ladies and gentlemen.

I want to make an rod support system using 3d printing.
It's something that'll go mounted on my tripod and will hold my camera (2 kg) on a raised end and two 15mm width metal rods on the other

Something like this (not exactly this one, it's just so you have an idea):
http://www.7cis.com/contents/media/rod-support-only.gif
(the camera would go on the right side in that picture)

I'm planning on printing just the support part (not the rods)

I was wondering if strong and flexible plastic would be fine for it
I realize the walls need to be thick but i don't know if the material can support the weight of my camera.

What do you guys think?

Read Message
Read Message
Previous Topic:We (I) need badges... and no stinking badges...
Next Topic:lamborghini pendant
Goto Forum:
   Go