Home » Community » Work in progress » From Sketch to Reality
Search Search  
From Sketch to Reality [message #60844] Sat, 26 January 2013 15:54 UTC Go to previous message
avatar TurtlesAreCool  is currently offline TurtlesAreCool
Messages: 267
Registered: October 2010
Go to my shop
Senior Member
I made this sketch the other day. I'm going to turn it into a vector drawing so it can be used to emboss or engrave something. After that, I'm not sure what I should do with it.

What do you think?

(Note - the design will be symmetrical. I'm right-handed, so the right side of the drawing always looks better than the left. That's why I often don't bother to draw both sides when it is symmetrical)

index.php?t=getfile&id=26188&private=0

  • Attachment: 1-angel.JPG
    (Size: 96.56KB, Downloaded 331 time(s))

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Stainless Steel Thin Sections Suggestions?
Next Topic:my first try at this check it out
Goto Forum:
   Go