Home » Community » 3D modeler needed » modeler needed to turn logo into 3d
Search Search  
modeler needed to turn logo into 3d [message #60249] Tue, 15 January 2013 09:37 UTC Go to previous message
avatar simonallchorn is currently offline simonallchorn
Messages: 1
Registered: December 2012
Go to all my models
Junior Member
I have a quite complex logo that was generated ages ago. I need this simplified to print as a round slightly domed button approx 32mm wide. Any help greatly received. Png attached but have svg etc

Thanks to everyone that showed an interest. All sorted now

  • Attachment: crest.png
    (Size: 236.19KB, Downloaded 90 time(s))

[Updated on: Wed, 16 January 2013 06:20 UTC]

Report message to a moderator
Message index

Read Message
Read Message
Previous Topic:3D Modeler needed for a Green Lantern ring
Next Topic:Xacti CA-100 camera (helmet) mount needed
Goto Forum:
   Go
Generate printable PDF   


Current Time: Fri May 24 22:15:33 UTC 2013