Home » Support » 3D Printing » Broken wires
Search Search  
Broken wires [message #59608] Fri, 04 January 2013 12:59 UTC Go to previous message
avatar bib993  is currently offline bib993
Messages: 36
Registered: November 2012
Go to my shop
Hi there!

When I received 5 copies of this 3D fractal model it came with a lot of broken wires. For the photo I took a less damaged item and showed it under an angle where it is clean, but you can see the thinnest wires look very fragile.


Do you think I should ask for a credit? So far I didn't because that was a relatively cheap model and that was my first order on Shapeways so I was still so happy to hold the models in my hands for the first time!

Since then, I did a more solid model and I am waiting for the order.

I have also ordered a larger version with relatively thin wires and this one is absolutely fantastic!


3D printing 3D fractals = more 3D fun!



Read Message
Read Message
Read Message
Previous Topic:Read density data from data sheet
Next Topic:Thin wire definition
Goto Forum: