Home » Support » 3D Printing » The Elegant Dog, In ceramic
Search Search  
The Elegant Dog, In ceramic [message #58968] Thu, 20 December 2012 17:08 UTC Go to previous message
avatar Tarum  is currently offline Tarum
Messages: 18
Registered: October 2010
Go to my shop
Junior Member
Hi all,
i really like to print this piece, The Elegant Dog, in ceramic, but i'm afraid that the 10cm version is too little and the printing process and glazing will broke it.
Is 10 cm from the point of the tail to the nose too small for printing the dog in this material?

Here the Dog, with all the parameters -> http://www.shapeways.com/shops/tarum
I placed it as first in the shop.

http://3.bp.blogspot.com/-xhAlow4IO6U/UNIU3F6LkwI/AAAAAAAAAQU/kIz_U2CObc0/s1600/cane1.jpg

If do yuo think it's not possible, would it be possible with the 15cm version?
Many thanks to all,

Andrea Tarabella

[Updated on: Thu, 20 December 2012 17:09 UTC]


http://andreatarabella.blogspot.it/

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Experiences using data from humster3D to print on shapeways
Next Topic:breaking risk
Goto Forum:
   Go