Home » Support » 3D Design » Designing a Case for a Samsung Phone
Search Search  
Designing a Case for a Samsung Phone [message #58857] Wed, 19 December 2012 03:30 UTC Go to previous message
avatar val5214 is currently offline val5214
Messages: 3
Registered: July 2012
Go to all my models
Junior Member
I have a samsung phone i would like to draw up a a cover for. I have drawn one up and uploaded one on this site and two others. I have been having trouble representing my phone in sketchup/rhino/blender and designing a cover around it. one particular problem i have is that the phone has a curved bottom and that is specially hard to recreate.

any idea on how i can accurately represent my phone in sketchup etc. ???


also another problem --
I made a snap on cover earlier, it did not fit but the lip around the edge was too stiff to push the phone into -- is there amount of length you can give an edge to make it "snap-able"

thanks
.
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Seeing fewer polys/vertices in the uploaded render than in my local blender render
Next Topic:Not all embossed letters printed
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 09:22:14 UTC 2013