Two-Tone Strong & Flexible model - It arrived! on Shapeways Discussions about 3D Printing

Home » Community » It arrived! » Two-Tone Strong & Flexible model

Two-Tone Strong & Flexible model [message #56882] Thu, 15 November 2012 10:10 UTC

equilux
Messages: 12
Registered: November 2010
Go to my shop

Junior Member

Here's an example of making a blue and white model using the Strong and Flexible material. I haven't seen the old dyed SF material so I can't compare it with the current colours, but I'm pretty impressed with the finish.

I wanted the two separate pieces to clip together, but this model is too long (at 15cm it's right on the limit for the polisher). The ends both fitted nicely, just not at the same time!