Iron Man HELMET 1:1 Model Fix - 3D modeler needed on Shapeways Discussions about 3D Printing

Home » Community » 3D modeler needed » Iron Man HELMET 1:1 Model Fix

Iron Man HELMET 1:1 Model Fix [message #56313] Mon, 05 November 2012 15:22 UTC

darksin
Messages: 3
Registered: October 2012
Go to my shop

Junior Member

Hi there. i found this page on the web of this guy who printed the ironman helmet .

http://www.instructables.com/id/3D-Printing-an-Ironman-Helme t/?ALLSTEPS

i tryed to upload the file but the walls are too thick.

can someone check if the scale of the file is ok .

	Iron Man HELMET 1:1 Model Fix By: darksin on Mon, 05 November 2012 15:22 UTC
	Re: Iron Man HELMET 1:1 Model Fix By: darksin on Mon, 05 November 2012 17:03 UTC
	Re: Iron Man HELMET 1:1 Model Fix By: INNERLEAF on Mon, 05 November 2012 19:20 UTC
	Re: Iron Man HELMET 1:1 Model Fix By: darksin on Mon, 05 November 2012 19:37 UTC
	Re: Iron Man HELMET 1:1 Model Fix By: INNERLEAF on Mon, 05 November 2012 19:39 UTC

Previous Topic:	9th anniversary present - ideas needed
Next Topic:	Looking for experienced 3D modeler for small challenging situation

Goto Forum:

Current Time: Tue May 21 07:41:33 UTC 2013

Don't miss Shapeways Live