Home » Support » 3D Design » Walls vs Embossed Detail
Search Search  
Walls vs Embossed Detail [message #55159] Wed, 10 October 2012 21:03 UTC Go to previous message
avatar jrey is currently offline jrey
Messages: 34
Registered: September 2012
Go to all my models
Member
Hey guys, I'm trying to design some things for print in stainless steel. The design guidelines say the minimum wire and wall is 3mm. But then there is embossed detail and/or walls supported that can be thinner. My question is where does the line cross, or rather how should I look at the model to determine which guideline to go by?

I'm really struggling with this specifically on extruded text.

Thanks for any help.
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Previous Topic:Miniature sword charm help/suggestions.
Next Topic:screws
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 12:27:15 UTC 2013