Home » Support » 3D Design » Are These Edges Okay Or Not?
Search Search  
Are These Edges Okay Or Not? [message #54789] Wed, 03 October 2012 14:42 UTC Go to previous message
avatar beagley is currently offline beagley
Messages: 7
Registered: October 2012
Go to all my models
Junior Member
Hi,
I am new to this.

I've designed a grating (holes in walls) using semicircles that connect at the points. There is NO gap. The points meet.

Are these edges (where the semicircles meet at the corners) okay for Shapeways?

Will my object print okay?

Thanks!

ATTACHED: Two images of my grating, as seen on a red surface. The gray area are holes.



[Updated on: Wed, 03 October 2012 14:45 UTC]

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Edge radius for sharp edges to look and feel 'good'
Next Topic:sketchup
Goto Forum:
   Go
Generate printable PDF   


Current Time: Fri May 24 20:32:55 UTC 2013