Home » Community » It arrived! » Dragonfly "Not So" Kinetic Statue
Search Search  
Dragonfly "Not So" Kinetic Statue [message #54097] Sat, 15 September 2012 21:18 UTC Go to previous message
avatar rithmikansur  is currently offline rithmikansur
Messages: 75
Registered: July 2012
Go to my shop
Member
Well, the prototype arrived. Aaaaannnd, it doesn't work Rolling Eyes
Not shapeways fault, it was just poor design on my part.
BUT, that's the purpose of prototyping right?

It looks good though, and i'm impressed with the WSF material in general.
for what feels like it's no heavier than if it were made out of paper, it's quite strong.

http://1.bp.blogspot.com/-ScN2FL1y1o4/UFMGyVyjoGI/AAAAAAAAAMo/BGOdB9w6G6A/s1600/photo+1.JPG

full write up on my blog. I don't know if linking to my blog breaks any rules here.
But, my daughter just woke up, and it seemed easier to post the link than copy and paste and relink every image with my 7mo. old daughter sitting on my lap trying to smash the keyboard Laughing
write up here...

[Updated on: Sat, 15 September 2012 21:21 UTC]


Blogging about shapeways, inventor, and anything else that crosses my mind
rithforms.blogspot.com

Read Message
Read Message
Read Message
Read Message
Previous Topic:By far the best 3 prints so far
Next Topic:"eastwood" to your own chair! ;-)
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.