Home » Support » 3D Design » Hollowing made more expensive?
Search Search  
Hollowing made more expensive? [message #53108] Sat, 25 August 2012 05:30 UTC Go to previous message
avatar LucasDailey  is currently offline LucasDailey
Messages: 3
Registered: August 2012
Go to all my models
Junior Member
I have a model with 5 main solid components. The cost to print is $91.86.

I didn't need the components solid, so I hollowed them out leaving some spanning areas, probably removing around 25%-50% of the material. I uploaded it and now the hollowed version costs $96.48 to print!

Any ideas how this happened?

Both models look correct, I thought maybe there was an error with the solid model that wasn't properly counting a section, but everything looks fine.

Read Message
Read Message
Read Message
Read Message
Previous Topic:"Engraved" fine detail
Next Topic:Painting directly onto the mesh surface, How??
Goto Forum:
   Go