Home » Community » It arrived! » 1st set of product test prints
Search Search  
1st set of product test prints [message #8497] Tue, 22 December 2009 15:49 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5314
Registered: September 2008
Go to my shop
Senior Member
I work here
This is my favorite. Although too small for me to wear I love how it came out.

http://www.shapeways.com/model/63675/printing_approved_brace let_.html

Every link is a 1mm thick. It looks so fragile. A larger version is going to come soon as I did have to work some of the links free of each other, and it would only fit a small wrist right now.

This one probably came out the most as I expected.

http://www.shapeways.com/model/64352/geared_up.html

The gears unfortunately don't move. But I haven't got to really try to clean it yet. Other then that fits great, and looks great.

This one you can't see the detail in the pic, and very little of it came through.

http://www.shapeways.com/model/49234/double_headed_coin.html

But if you look at the very low lettering areas, you can just make it out (not in the picture, on the actual) Most of the ribs on the outside of the coin didn't survive which surprised me...

This one I took off because it was too small also but came out wonderfully so I figured I'd share that.

index.php?t=getfile&id=2121&private=0

Last but not least, this week should be getting my mayan pendent, and my Flicka 2.0/2,1 test in stainless!

  • Attachment: IMG_0337.jpg
    (Size: 438.12KB, Downloaded 502 time(s))


Your friendly neighborhood Moderman
michael@shapeways.com

Read Message
Read Message
Previous Topic:Hollow Cube by OSKAR
Next Topic:My first 3D print
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.