Home » Support » 3D Design » How do I fix these corner gaps?
Search Search  
How do I fix these corner gaps? [message #57489] Mon, 26 November 2012 15:17 UTC Go to previous message
avatar DrBill37  is currently offline DrBill37
Messages: 6
Registered: October 2012
Go to my shop
Junior Member
Hello

Can someone please tell me what approach is needed to fill in the gaps seen in the attached model of a cube? Is there some magical MeshLab filter that can be used to do this? -I've tried a few with no luck (Convex Hull fills them in but creates a snubbed cut off corner, whereas I need the edge to be a sharp corner.

thanks
Bill

  • Attachment: Cube_3.stl
    (Size: 23.85KB, Downloaded 38 time(s))

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:"Best Practice" guide for standard mechanical problems?
Next Topic:Why is my Coffee Cup filled in?
Goto Forum:
   Go