Home » Support » 3D Design » Turn engraving into a hole
Search Search  
Turn engraving into a hole [message #57018] Sun, 18 November 2012 09:09 UTC Go to previous message
avatar a3333326  is currently offline a3333326
Messages: 5
Registered: September 2012
Go to all my models
Junior Member
Hi,

I was wondering is it possible to turn an engraving into a hole? Such that it not just an engrave on a ring but something like an extraction.

Thank you very much.

Regards,
Wade

Read Message
Read Message
Previous Topic:Ring design
Next Topic:I can't seem to get the right scale / 3ds max
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.