Home » Community » General Discussion » Getting a Gloss Finish
Search Search  
Getting a Gloss Finish [message #56909] Thu, 15 November 2012 18:49 UTC Go to previous message
avatar avasassi is currently offline avasassi
Messages: 4
Registered: August 2012
Go to all my models
Junior Member
Hi! I designed a model that is relatively simple and has two halves, and I would like the top half to have a white gloss finish, and the bottom to have a colored satin finish. What is the best way to achieve this?

If I was to paint the model, would it require any surface finishing on my part, or is the WSF polished enough that a coat of paint would go on smooth?

Is there any kind of coating we could apply to make the top glossy, and the bottom have a satin finish texture?

Thank you.
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:James Bond "Skyfall" Aston martin was 3D Printed.
Next Topic:Starcraft Models
Goto Forum:
   Go
Generate printable PDF   


Current Time: Fri May 24 00:36:04 UTC 2013