Home » Community » 3D modeler needed » Iron Man HELMET 1:1 Model Fix
Search Search  
Iron Man HELMET 1:1 Model Fix [message #56313] Mon, 05 November 2012 15:22 UTC Go to previous message
avatar darksin  is currently offline darksin
Messages: 3
Registered: October 2012
Go to my shop
Junior Member
Hi there. i found this page on the web of this guy who printed the ironman helmet .

http://www.instructables.com/id/3D-Printing-an-Ironman-Helme t/?ALLSTEPS

i tryed to upload the file but the walls are too thick.

can someone check if the scale of the file is ok .

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:9th anniversary present - ideas needed
Next Topic:Looking for experienced 3D modeler for small challenging situation
Goto Forum:
   Go