Home » Support » 3D Printing » Rounded/Polished Side?
Search Search  
Rounded/Polished Side? [message #56060] Sat, 27 October 2012 20:41 UTC Go to previous message
avatar N8N1 is currently offline N8N1
Messages: 5
Registered: September 2012
Go to all my models
Junior Member
Hello, I recently printed myself a necklace type medallion, but the back side of the emblem is rounded to a soft edge while the front is not. I printed this in the strong white and flexible as a prototype. But before I print my final (In Shiney Silver) I would like to take care of this problem. Any idea on how to specify which side should be considered the front so it can have smoother edges than the back?? If any question is needed feel free to look at my project in My Models.

[Updated on: Sat, 27 October 2012 20:43 UTC]

N8N
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Printing Grandpa is giving issues
Next Topic:moving parts
Goto Forum:
   Go
Generate printable PDF   


Current Time: Thu May 23 21:37:46 UTC 2013