Home » Community » General Discussion » Printing Sterling Silver Stone Settings.
Search Search  
Printing Sterling Silver Stone Settings. [message #55582] Thu, 18 October 2012 16:27 UTC Go to previous message
avatar Sam.Gratz is currently offline Sam.Gratz
Messages: 2
Registered: November 2011
Go to all my models
Junior Member
Hello,

Has anyone experimented with printing bezel cups and prong settings in Sterling Silver, then trying to set a stone in it? If so, do you have any suggestions on the setting process or wall thickness issues? I'm mostly worried about being able to bend over the rim of the cup or the prong in the printed material. Any information would be beyond appreciated.
-Sam

-Sam Gratz
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Previous Topic:Will it print? I am so new it isn't funny
Next Topic:3d Software doesnt make sense. Someone please give me some advice
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 12:18:49 UTC 2013