Modeller needed for control grips. - 3D modeler needed on Shapeways Discussions about 3D Printing

Home » Community » 3D modeler needed » Modeller needed for control grips.

Modeller needed for control grips. [message #55398] Mon, 15 October 2012 20:37 UTC

Komodo
Messages: 1
Registered: July 2012
Go to all my models

Junior Member

Hi,

I'm looking to get a range of control grips designed. I have the techincal drawings for them. They are needed to be hollow with a wall thickness of 3mm and if possible made in 3dsmax. Looking for rough idea of design cost for an time that is aprox 15cm high.

Cheers

Rich

Report message to a moderator

Profile PM

Reply Quote

Message index