Home » Support » 3D Printing » Printing Silver - production questions
Search Search  
Printing Silver - production questions [message #55373] Mon, 15 October 2012 09:16 UTC Go to previous message
avatar AmLachDesigns is currently offline AmLachDesigns
Messages: 325
Registered: September 2011
Go to my shop
Senior Member
Hi everyone,

I have some questions that I hope someone can answer relating to printing in silver:

1. What is the material used to print the object used in the casting of the silver piece?

2. When the sprue attachment is removed how is the polishing done, by hand, tumbling or ...?

3. When you specify glossy finish, how is this achieved? Is this tumbling etc?

Thanks
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Previous Topic:Threaded holes created in Alibre
Next Topic:Ring smaller than expected
Goto Forum:
   Go
Generate printable PDF