Home » Community » General Discussion » Model may or may not have issues
Search Search  
Model may or may not have issues [message #55146] Wed, 10 October 2012 16:16 UTC Go to previous message
avatar WolframTeam  is currently offline WolframTeam
Messages: 1
Registered: March 2012
Go to my shop
Junior Member
I've sent an email to Customer Service and received no reply, so I am hoping this will get me an answer:

My coworker in our UK office placed an order for an item we have on our shop:

http://www.shapeways.com/shops/wolfram

The item was printed but it looked as if it had a water stain on it. The representative told her that it was because we only had one hole in the model and that reprinting it would not guarantee that it would not happen again.

I had placed an order for the exact same item and it came in looking perfect. My question is how can we fix the model so that this will not happen? Is it a size issue or something else?

Read Message
Read Message
Read Message
Previous Topic:How often do you do a FUD Print? Do you combine S&H, when possible, with follow-up Orders?
Next Topic:Model print in silver "not available"?
Goto Forum:
   Go