Home » Community » Work in progress » Centaur figure
Search Search  
Centaur figure [message #54981] Sat, 06 October 2012 19:41 UTC Go to previous message
avatar Michael_Milano  is currently offline Michael_Milano
Messages: 38
Registered: November 2009
Go to my shop
]Hello, It has been a while since being active on Shapeways, and can't believe the level of prints from just a few years ago. I have recently been helping people with their models and wanted to start uploading some of my own again. Here is a Centaur, 60mm in height. If anyone has any suggestions, or would like it at a specific height let me know. There is also a turntable on the Shapeways page. Hope you like it!

Best, mike



  • Attachment: shapeways.jpg
    (Size: 121.16KB, Downloaded 309 time(s))


Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Lemming
Next Topic:PC Case from SWF
Goto Forum: